Below are comparisons of the different levels of services I offer. Choose the one that fits your need and contact me with any questions you may have regarding what will be inspected beyond the listings below.

Notice: My inspections are NOT to satisfy the DMV / DPS / State Registration requirement of any State. Please contact a local licensed shop for an inspection.

Safety Inspection $300.00

All safety related systems in the unit.

  • Perform and document LP gas timed leak test at cooktop burner spud for 5 minutes at 8 inches of water column gas pressure

  • Test the Ground Fault Circuit Interrupter (GFCI) circuits in the 6 foot range of the water areas of the bathroom, kitchen and exterior receptacles

  • Test all wall receptacles for correct polarity and ground fault

  • Test the exterior skin for hot skin that would cause electrical shock

  • Emergency Exit Windows Verify all safety windows are operational

  • Fire Extinguisher - Verify unit is secure in bracket 24" to door and dial indicates extinguisher is fully charged and document expiration date

  • Smoke/Fire Detector - Test and verify operation of unit and document expiration date of detector

  • Carbon Monoxide Detector (if applicable) - Test and verify operation of unit and document expiration date of detector

  • LP Gas Detector - Verify gas detection and audio alarm. Document expiration date of detector

  • Verify the rubber grommet is properly sealed around LP gas line of water heater

*Approximately 2-3 hours for inspection.

Premier Inspection $500.00 - $1200.00 +

The Premier Inspection includes Safety and Essential Plus Inspections. In addition to Fluid Analysis of the Chassis Engine Oil, Engine Coolant, and Transmission Fluid (1 each), Plus the Generator Engine Oil, and Coolant if equipped (1 each) for a total of 5 Fluid Analysis tests. A minimum of 50-100 photos. The additional photos are generally concentrated on the interior finishes and of the Fluid Analysis samples.

  • Roof

  • Sidewall and End Caps

  • Slideout Rooms

  • Awnings and Slideout Toppers

  • Chassis Turn Signal and Running Lights (12 volt DC)

  • 120 Volt AC Electrical System (house type power)

  • Generator if installed *strongly recommend performing oil analysis to determine internal combustion engine component condition.

  • Inverter if installed

  • Coach Battery System (12 volt DC deep cycle Battery Electrical System)

  • Fresh Water System

  • Waste Water Systems (Gray and Black Water)

  • LP Gas System

  • DOT Cylinders - if equipped

  • ASME tank - if equipped

  • Refrigerator

  • Water Heater

  • Furnace

  • Cooktop/ Stove

  • Air Conditioner(s)

  • Washer/ Dryer

  • Microwave/Convection Oven

  • Dishwasher - if installed

  • In House Vacuum System if installed

  • Electric Fireplace if installed

  • Cooktop Exhaust Fan

  • Ceiling Mounted Fans and Ceiling Exhaust Vents

  • Interior Conditions and Appearance

  • Cabinets and Closet Condition

  • Furniture

  • Entertainment System

  • Shower/Tub Enclosure

  • Running Gear (Towables)

  • Hitch System/Hook Up

  • Leveling System

  • Weight Labels and Data Plates

*Approximately 6-8+ hours for inspection.

 

Fluid Analysis

A Fluid Analysis includes the following for each type of unit. If you choose the Safety, Essential inspections these items can be added on as a la cart. Starting at $100 and $10 less for each additional. For example: Oil $100, Coolant $90, Transmission $80 if order is for all three totaling $270.00.

Motorhomes - Engine Oil, Engine Coolant, Transmission Fluid

Tow & Towed vehicles (toad) - Engine Oil, Engine Coolant, Transmission Fluid

Generators - Engine Oil, Engine Coolant (if equipped)

Walkthrough for New or Used RV's - $300.00 for 4 hours

Did you just buy a new or used RV and you want to learn more about the amenities that are in the RV? Want a better understanding on how to turn on/off items in different circumstances like on 12V vs 30/50amp? How to work slides without power, how to clean tanks, get rid of a pyramid or troubleshoot the little things. Maybe a good routine to set up or tear down at a campground. All these things can be answered in a Walkthrough. In four hours you get my attention and can ask all the questions possible or go over any amenity you want. $200.00 four hour time frame.

Choose your RV Safety Inspection and contact me for a exact quote of all services.

Please note: A contract and payment can be arranged along with location and requirements for the inspection. The RV unit to be inspected should be hooked up to full hookups (Power, Water, & Sewer). Inclement weather may cause a delay or cancelation of the inspection.

  • Unit should have the Refrigerator/Freezer turned on 12 hours prior to inspection to cool and check temperature.

  • Unit should be level and enough room on all sides to extend slides and awning.

  • Unit should have enough propane, gas or diesel to run tests.

  • Unit should be connected to power 30/50 amp.

  • Batteries should be connected and charged.

  • All Keys to doors, storage doors should be onsite.

  • A water hose and sewer hose should be onsite.

  • If its found that full hook-ups are not available at units current location, consider placing unit in a RV Park or some items may not be fully testable.

  • Due to insurance a drivable will only be started to run engine, the unit will not be driven by me. I can however be a passenger if the owner drives and I can note any issues observed.

Gallery of Prior Inspections